stillshunter
a man of resolve, a man of conviction
State Convenor - ACT
Group Buy Associate
2015 Sabbatical Fail
- Joined
- Apr 24, 2014
- Location
- Walbunja country
Just completed v0.1 of the Razorack®.* I know it's rough, I invested near to no time in the finishing (I mean there will be no screws in the final version!). The intent here is to trial the Razorack® for a few weeks and evolve the design based on annoyances and inspiration from constant real-life use....and feedback.
So I'd be keen to hear any suggestions, input, etc. to transition to an improved v0.2 or even v1.0. Also more than happy to share measurements, design, etc. as the project develops. I intend to keep the design of the Razorack® simple, the construction low cost, and the IP under GNU licensing
I think I'm happy enough with the width, though not quite sure about the height. Having said that it's hard to find a happy medium with the variations even in my modest selection. Also the intent is to have a few slots - probably at the ends - available for straights and SEs. Initial thinking is furthest left and right drilled wider for a straight each side and then two further wider holes for SE handles - there's no way the GEM Featherweight (on loan) will fit as is, though it looks as though the same gauge I'd use for straights would work for the SE.
* Razorack® is a registered trademark of Stillshunter Piss-Take Industries P/L
So I'd be keen to hear any suggestions, input, etc. to transition to an improved v0.2 or even v1.0. Also more than happy to share measurements, design, etc. as the project develops. I intend to keep the design of the Razorack® simple, the construction low cost, and the IP under GNU licensing
I think I'm happy enough with the width, though not quite sure about the height. Having said that it's hard to find a happy medium with the variations even in my modest selection. Also the intent is to have a few slots - probably at the ends - available for straights and SEs. Initial thinking is furthest left and right drilled wider for a straight each side and then two further wider holes for SE handles - there's no way the GEM Featherweight (on loan) will fit as is, though it looks as though the same gauge I'd use for straights would work for the SE.
* Razorack® is a registered trademark of Stillshunter Piss-Take Industries P/L
Last edited: